Sweeper charger use

[quangongzi]

Before using this charger, please read this manual carefully so that you can better use the product.
During the use of this product, in order to ensure the personal safety of the operator and the safe and stable operation of the equipment, the following carefully observe the warning!
Make sure that the DC plug is securely connected to the socket. If the plug and socket are damaged, loosened or the temperature is too high, should stop using, and immediately replace the damaged parts. Plug or disconnect the DC plug can only be in the charger does not work, so you can avoid the plug caused by the arc. To avoid damage to the charger cable, do not pull, move, or shake the cable on both sides when the plug is disconnected from the cable holder. Danger!Small Road Roller - Shanghai Doan Machinery Technology Co.,Ltd

Do not touch the battery terminals and the plugs of the DC plug.
note!
If you need to stop charging during charging, disconnect the AC plug before disconnecting the DC plug and unplug the DC plug from the outlet after disconnecting the power supply from the charger. Before you use the product, please note the following:
Charger A: 200 ~ 240VAC B: 100 ~ 120 VAC Charging: The charging voltage of the charger is in the range of AC200V ~ 240V or AC100V ~ 120V 50 / 60Hz /p>unidirectional alternating current, and has good grounding terminal. Machine to match the rated voltage of the battery and the battery capacity should be within the rated range. The charger is only suitable for the specified type of battery pack, please refer to the nameplate. Connect the battery to the motor firmly.
When the key switch is turned on (ON) position prohibit access, dismantle the battery Machine Description Operating performance
The sweeper must be operated by a fixed operator on a relatively flat surface of cement, asphalt, tiles, etc. (flat and vacuum) to clean dust or light garbage.Conventions
Forward, backward, left or right can be sitting on the driver's seat by the operator with a palm-controlled steering wheel adjustment. Control panel and operating parts
 Power and light switch Horn button Turn signal switch
Stop button: When pressed, the main brush and side brush stop rotating after lifting.
Forward / reverse switch: switch forward to the forward gear, depress the accelerator pedal, sweeping machine can move forward.
Switch to the middle, sweeping machine stationary. Switch back to back gear, depress the accelerator pedal, sweeping machine backward.
construction of rotating machines
construction technology of bored
chip spreader auction